Wallpapering is one of the final stages of repair and one of the most important.
It is the wallpaper that can make the house cozy and unique, and an unsuccessful, incorrect pasting can nullify all previous efforts.

To begin with, you just need to make a choice and decide which wallpaper is preferable. Now the choice is so great that everything depends on the imagination and the requirements for functionality. Today we will consider the simplest option: a paper wallpaper sticker.

When pasting wallpaper, the main thing is to align the walls well and bring out the corners, then pasting will not be difficult. The wall must be cleaned of dust and primed before pasting, then it will be more convenient and easier to glue. It is better to remove the sockets and switches after turning off the electricity. After that, the required length of the sheet is measured, plus 4-5 cm, the excess will simply be cut off after drying, and this will help avoid problems if the ceiling is uneven. The glue is selected for the type of wallpaper, any hardware store will help you choose the right one. It is better to take glue with an application indicator, you can immediately see where there is no glue on the sheet yet. Recommendations for cooking are on each pack of glue. After the first sheet has been measured and cut off, you can cut all the others along it, without forgetting to adjust the drawing, if necessary.

Paper cloths are easier to glue than all the others, the glue itself is applied to them both on the wall and on the wallpaper, the cut sheet is impregnated with glue, within 5-10 minutes. It is better to glue together, one applies a sheet to the wall at the top, the other supports the sheet so that it does not curl and tear. The canvas is pressed tightly against the wall and smoothed with a special spatula, roller or just a clean dry cloth from the middle to the edges. You need to make sure that there are no large air bubbles under the wallpaper. The little bubbles will disappear by themselves when the wallpaper dries. It is better to start gluing paper wallpaper from the window. The second sheet of paper wallpaper is glued overlap on the first about 1 cm, as well as all subsequent ones.

An important stage is the pasting of corners. The sheet is wound at an angle, so that the wallpaper strip on the perpendicular wall is 5-6 cm. The canvas is pressed tightly in the corner. The last pieces of wallpaper are glued over windows and doors. After drying the glued wallpaper, they are carefully cut off at the level of the baseboard with a special knife, which is easy enough to buy at any hardware store. Holes are cut in the places of switches and sockets.

That's it, the wallpaper sticker is complete. It's time to enjoy the result of your labors and the updated interior. Играйте на своем пути к богатству — раскрывая преимущества казино pin ap634